Frozen pipe claims rank among the most damaging winter losses in State Farm’s national claims data. A small split can release water for hours before anyone notices, and a hard Connecticut cold snap can turn an overlooked pipe in a wall cavity, garage, or crawl space into a major cleanup. Knowing what to do before that happens makes all the difference.
We’ve worked through Connecticut winters since 1978, and preparation starts with understanding why pipes fail in the first place. Ice creates the problem, but pressure is usually what causes the break.
Why Pipes Freeze and Burst
A pipe typically doesn’t split at the exact location where water freezes. As water turns to ice, it expands by roughly 9 percent and forms a blockage. If more water freezes on the supply side of that blockage, pressure builds in the trapped section between the ice and a closed faucet or fixture.
That trapped pressure looks for the weakest point (a fitting, valve, or connection) and the rupture may occur several feet away from the frozen area, often where there’s little or no visible ice. This is why a pipe can seem intact while frozen, then start leaking as temperatures rise and the ice melts.
Letting a vulnerable faucet drip gives that trapped pressure a route to escape rather than building against the pipe wall. The section upstream of an ice blockage is less likely to burst because water can often move back toward the supply source. Downstream, a closed faucet creates a dead end.
Which Pipes in a Glastonbury Home Are Most at Risk
The highest-risk plumbing runs outside the home’s heated living space. Exterior wall plumbing, pipes in unheated garages, crawl spaces, basement utility rooms, and cabinets along outside walls can lose heat quickly during prolonged cold.
Glastonbury has a meaningful share of older housing stock. NeighborhoodScout data indicates roughly 39 percent of homes were built before 1970. Pipes in older additions, rim joists, exterior wall cavities, and crawl spaces deserve a close look before winter arrives, since those layouts often don’t reflect current insulation practices.
Pay particular attention to these locations:
- Kitchen and Bathroom Cabinets: Supply lines along exterior walls can get cold when cabinet doors stay closed.
- Crawl Spaces and Garages: These areas often lack the steady warmth that protects interior plumbing.
- Outdoor Faucet Lines: Hose bib supply lines can freeze after a hose is left connected or an interior shutoff stays open.
- Basement Utility Areas: Pipes near foundation walls, windows, and bulkhead doors are exposed to cold air leaks.
Homes with hydronic boiler heat (a system that circulates heated water through pipes to radiators or baseboards) still have domestic water lines that need protection. Heating the living area doesn’t necessarily warm an exterior wall cavity or enclosed crawl space enough to protect a small supply line.
Practical Steps to Prevent Frozen Pipes This Winter
Keep Indoor Temperatures Steady
Maintain heat throughout the home, including overnight and while traveling. Opening cabinet doors under sinks can help warmer room air reach plumbing along exterior walls. Close garage doors and seal obvious drafts around utility spaces where plumbing is exposed.
Use a Slow Faucet Drip
Let a faucet served by a vulnerable pipe drip slightly during severe cold. A partially open faucet helps relieve the pressure that can build downstream of an ice blockage.
Insulate Exposed Plumbing
Install a foam pipe sleeve on accessible water lines in unheated areas. For pipes with repeated freeze problems, heat tape (an electrically powered warming strip installed along the pipe) can provide added protection when selected and installed according to manufacturer instructions.
Winterize Outdoor Connections
Disconnect and drain garden hoses before freezing weather. Shut off the interior supply valve to an outdoor faucet if one exists, then open the exterior faucet to drain remaining water. Even a frost-free hose bib needs its hose removed. Leave it connected and water stays trapped inside.
What to Do If a Pipe Freezes
A faucet that produces only a trickle (or stops flowing entirely) may signal a frozen pipe. Start by opening the affected faucet. If you can safely identify the frozen section, warm the area gradually using household heat: raise the room temperature or use a hair dryer on a low setting.
Don’t use an open flame, blowtorch, or heat gun on plumbing. These methods can damage pipe materials, ignite nearby building materials, or overheat a confined space. If the frozen section is hidden behind a wall, near electrical wiring, or otherwise difficult to reach, attempting a DIY thaw creates more risk than it resolves.
Before cold weather arrives, every household should locate the main water shutoff valve. If a pipe cracks during a freeze-thaw cycle, closing that valve quickly limits how much water gets released.
Stop DIY efforts and seek plumbing help if you notice any of these warning signs:
- Water stains or bulging pipe sections
- Active leaking
- No water flow from multiple fixtures
- A frozen pipe inside a wall, ceiling, or inaccessible crawl space
Our plumbers can locate the affected run, thaw it safely, check for cracks, and address the conditions that allowed the freeze to happen.
When Prevention Isn’t Enough
Preparation lowers the odds of damage, but an extended cold snap can still overwhelm a poorly insulated wall cavity or an exposed supply line. When that happens, the problem needs a prompt repair. More prevention tips won’t help at that point.
At Delponte Plumbing & Heating, we provide emergency, same-day, and weekend service for frozen and burst pipes, backed by licensed and insured professionals.
If a pipe freezes or leaks despite your preparation, contact us at (860) 821-4319 and we can assess the situation and protect your plumbing.